8 replies
by gsquared
I used to have such a Zip drive, way back in the '90s. I don't know if such still exists.
At the time, it plugged in as a floppy drive, was bootable, etc.
I looked at www.iomega.com and the closest I see to that now is an IDE drive. That means it would go in place of a hard drive, not a floppy drive. So, unless you can find a still working copy from the early '90s, I don't think you can do what you're looking for.
by spidershrek
by spidershrek
by xt john
by thechas
While a ZIP drive is the same form factor as a 3 1/2" floppy drive, you cannot use the floppy drive interface for a ZIP drive. Nor, can you use floppy disks in a ZIP drive.
An Internal ZIP drive uses either IDE or SCSI connections.
I recommend connecting the ZIP drive as Master or Slave on the same cable as your CD-ROM drive. The lowest drive letter that DOS or Windows will assign to the ZIP drive is D:
If the software you are using is hard coded to write to the A: drive, a floppy disk is your only option. Even the old "Super-Disk", that would read floppy disks, was an IDE device for the large disk.
As far as I know, there is no way to assign the A: or B: drive letters reserved for floppy drives to an IDE drive.
Chas
by hal 9000
Well everyone is correct the current crop of Zip Drives are IDE so you'll at the very least need a Spare IDE Connection which may be a problem if you have 2 HDD's and 2 Optical's you would need a PCI/ISA [i]depending on the age of the unit[/i] to IDE converter and you couldn't run the Zip off that it would have to be connected to one of the On Board IDE Channels.
As for booting you are unable to use either the A or B option but you could change the boot option in BIOS to Zip, CD, HDD and that may work if the boot disk isn't required in the A Drive and BIOS will support this option quite a few of the older BIOS's don't. This is something that you'll need to look at yourself on that particular machine.
In answer to your second question the answer is [b]No[/b] there is no converter that you can use you need a IDE port available and it would be better if it was a primary one. Even then it may not work as the M'Board may not support a Zip Drive as a device to read a bot file from. The only thing that I can think of here is the Old Amstrad running DOS which had Dual Floppies that you had to boot from a Floppy to get started but I'm supposing that this is some form of security feature that is preventing some form of Windows from Booting as I really don't think that you'll see to many of those old Amstrad Dos units still around working.
Col
by exp
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending