Discussion Locked

1ST boot after install no video in XP

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I formated my hard drive and did a clean install of xp pro and after the 1st boot I get the windows xp banner rolling across the screen and then i lose video please help, ive tried everything I can think of. I have a pII 300 mhz with 256 pc 133 ram and nvidia 3d on board graphics. no other cards are installed at this time.

6 replies

by dmiles

First check to make sure that memory modules are seated properly and are the same type.

Secondly check the graphics card drivers to see if you have the updated drivers to support Win XP.

by jschein

hmm... 300mhz pc with xp?...

Let's see, did you try booting into safe mode? (hit f8 upon bootup)...

Did you install easy cd creator with the updates?

Did you install PC Anywhere without the updates?

If you have no clue, boot into safe mode and goto add remove programs and take off the last programs installed one by one... one of them is hanging your system.

by pctech

Is this the first time you have tried to install XP Pro onto this system? Should this be the case, I would check the hardware for compatability with XP Pro. Check to see if there is a BIOS flash available for your motherboard. Also check the BIOS and see if there is an option for choosing between PIC and APIC, if there is chose the APIC setting. You may also want to disable any caching in the BIOS. Should disabling the caching allow you to successfully install XP Pro, then try enabling the caching and see if XP will still boot, if not replace the motherboard, for without caching the system will perform painfully slow. You will not get much performance on this system anyway with XP installed.

Should XP Pro already have been installed on this computer, I would look for hardware failure or instability.

I hope this helps

by thechas

Try a different monitor.

The default first video settings for XP do not work with some monitors.

I fought with this problem for months on my setup bench before the idea to try a different monitor struck me.

Chas

by escoserv

Were you able to use Windows XP before?
if that is the case,
Hit f8 at the start up,
go to safe mode,
go to display properties of your computer, easiest, "right click somewhere on the desktop, choose properties" go to settings and advanced.
check for refresh rate and reduce the refresh rate if it is set to a high number.
If the refresh rate is set to a higher number than what your monitor can support, you end up with a black screen but the hard drive still works and you can even shut down windows if you know how to do it with closed eyes.
if not, try to roll back the driver and restart again. last option you may need to install the original driver if that doesnt crash! or download the updated one from internet.

This discussion is closed to new replies.