9 replies
by jschein
Selecting the files, moving them, wiping out pc, moving back files will not restore the pc to the way it was.
2 programs I recommend for imaging:
Powerquest Drive Image Pro 4.0 (very easy to make an image)
Norton Ghost ( a little more difficult )
Defrag your hard drive first, then use one of these programs to "Image" your drive onto another hard drive. Then you can fdisk you drive, wiping out all the data, and resize it to what you need. If it is fat16, fat32, the image is scalable to where you can change the size when imaging back. If it is NTFS, you can only make your partitions bigger.
Good luck.
by jeremy
Poster rated this answer.
by thechas
If the drive is simply a data drive, your plan should work just fine.
If you boot from the drive, you need to format it as a bootable drive for your OS, and then copy the files over.
I have done this many a time for both DOS and Windows systems.
Now, what are you hoping to accomplish by this?
If you are looking to change the partition size, yes, this is the safe way to do it.
If you are attempting to recover bad sectors, I would advise against it.
If you have enough bad sectors to cause problems, you should replace the drive.
If you are looking for the benefits of a clean install, you can't get there this way. A simple backup and restore will bring you right back to where you were.
Chas
by jeremy
Poster rated this answer.
by wyrmlord
Yes, if this is only a data disk, you can copy them aside before reformatting. If it's anything else, it's best to make an image (DriveImage, Ghost, or Acronis TrueImage ).
But if all you want is resizing, you don't have to copy/move a byte. Just use some reliable partitioning software, like Partition Expert, TrueImage, or Partition Magic. If you're feeling totally unsure, you may image the disk before, but really, there's no need to.
All of the above programs have VERY good help so there's no point giving step-by-step advice, just go with the flow and you'll be fine.
best of luck,
by jeremy
Poster rated this answer.
by aborowka
I assume that you have Windows 9x on old system. The cheapest solution to do it is to download shareware called XXCOPY.EXE. Then you install bare OS on new drive. Select new drive as slave and install it on old system. After boot, go to command prompt and type: XXCOPY C: D: /CLONE.
Boot system with new disk and everything should be fine.
by jeremy
Poster rated this answer.
by jeremy
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending