Discussion Locked

Black monitor

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi
When i switch on my PC i hear a long Beeeep and the monitor stays blank.
I have checked all cable connections and all are in place. My graphics card is OK, the DIMMs of memory (64mb/128mb)are OK, and the monitor works
All the above have been tested.
The other thing is that the PC switches off on it's own after a couple of minutes.
The spec is: P2 400Cel, TNT2 G.card, 192MB, 6.5GB
Any suggestions please.
Thanks,Yiotie

9 replies

by dmiles

Did you upgrade the memory?
Check the memory for compatibilty,make sure that you have correct type of memory

If you see the cursor blinking in upper left corner then you may have a problem with operating system loading,the problem may be a graphics card driver update,go to manufacturers web site and download the latest driver

Insert Windows98 startup disk in floppy,boot computer at command prompt type fdisk /mbr,eject the disk and reboot.

by cisco_kid

make sure the harddrive ribbon cable is plugged in good to the hardrive itself as well as the mobo

by ann777

One long beep is usually a memory error (check your beep codes against your systemboard documentation to be sure about what this beep means). Make sure the memory is properly seated in their slots.

"The other thing is that the PC switches off on it's own after a couple of minutes." <-- this is a problem and could be indicative of a overheating problem or a power supply problem.

Are you sure all the fans (especially on the cpu and the power supply) still operate? What is the wattageof the power supply? What other hardware do you have here -- # CD drives? # hdds? etc.

by thechas

If this is an AGP graphics card, it is possible that the card is not fully seated into the AGP slot.

The AGP slot uses interleaved connections, so the card need only be a few 0.001" from being seated to cause problems.

When I suspect that the card is not seated, I remove the bracket from the card, and see if the card now sits deeper into the AGP port.

If so, I modify the bracket as needed to allow the card to seat properly.

You can also try a PCI card.
I had one motherboard where the AGP socket itself failed after 6 months.
Switching to a PCI video card allowed me to recover the system.

Chas

This discussion is closed to new replies.