Question Locked

Broken PS2 Keyboard pin & F1 message

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am trying to fix an old compaq pc for a friend and find that the F1 keyboard error message he is getting appears due to a broken PS2 keyboard port. The broken pin is so far in it is impossible to get it out with pliers, tweezers or anything else. using a usb keyboard doesn't solve the problem we still get "F1 keyboard error" Is there a solution short of replacing the motherboard? The usb ports seem ok as I plugged an mp3 thumb drive player into them and it worked fine even without booting into windows just ran of the pc's power.

4 replies

by collignond

If you use the USB keyboard, can you get into the bios?

if yes you can go to the general settings in the bios and change the hault on all errors to all except keyboard. this will stop it from haulting the boot at the keyboard error message and allow you to boot into windows where it will install the usb keyboard drivers.

by phil.oconnell

But no luck. The F1 error comes up whatever I try, usb keyboard or no keyboard. Owner told me did move pc around around the flat a few times and it looks like he may have damaged the pin and the port then. I suspect it is recognising a problem with the broken pin in the keyboard port and registering the error straightaway. If I could get into the BIOS I could simply set it to ignore all errors on start up but I need a keyboard working to do that. I have told the guy I think he wil lhave to look at buying a new mobo as I can't see a way around it. Just thought someone might have a solution before I give up and get a new mobo.

by hal 9000

To remove the broken pin these will be available at any decent Medical Supply Store but you'll need to find one first.

Failing that I've successfully replaced the PS2 Ports on several M'Boards by removing ones from dead M'Boards and soldering them onto the affected M'Board. But you need the right equipment to do this and be very good at soldering as you can create cross tracks quite easily.

Also sometimes depending on the make of the M'Board you can manage to push the pin straight through and out the back with a piece of fine wire but this depends on the socket and if it has an open back.

If you look at some fine Locking Forceps they should be capable of reaching into the Hole and then wen closed lock onto the broken pin but because of what these instruments are they are not cheap and if this is a one use job they may not be worth the cost but a decent Soldering Iron that has an Earthed Tip and is Temp Controlled should be in everyones tool kit. Set this to 312 C and then with a solder sucker suck off the solder and when all the solder is removed you can then pull out the socket generally this is a bank of 2 PS2 sockets but remember to allow them to cool down first. You need to set the soldering iron to 312 C because solder melts at 310 C and you need it slightly hotter to remove the solder with. When you solder in a new socket remember to us a High Silver Content solder that is fine and work of diagonally opposite solder points to avoid cross bridging 2 adjacent connections.

Of course if this is a cheap rubbish M'Board just replace it as your customer will end up with something better than they had previously but remember that if it's an off the shelf unit the Recovery CD will not work and you'll need to perform a load with a work copy off the same type CD.

Col

This discussion is closed to new replies.