Discussion Locked

.cab files

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
how do i backup the .cab files from my hard drive to a new folder on c: drive so that any lost files,drivers etc can be found by windows on reboot or is there a better way of storing so i dont have to put the windows disc in the cd-rom drive

4 replies

by thechas

I simply copy the Windows CD onto the hard drive, and install Windows from there.

I use a separate logical drive, and copy the Windows CD and any needed device drivers to separate folders on the drive.

folders such as:
C:\Win98
C:\Drivers
Under drivers, I have a sub-folder for each device.

On a running system, you can use regedit to change the source drive for the Windows installation. The specific key varies by the version of Windows.

Caution: Improper use of regedit can cause Windows to not load.
Proceed with caution.

Chas

by fred07

I use a micron pc boot disk from their site and it does an auto cab install and installs windows from there. ie C: drive.

by peab4yougo

I've even gone so far as to just move D:\win98\*.* to the C:\Win98 directory, and run setup. You don't need the whole CD, just the contents of the WIN98 directory.

by wlbowers

Most everyone copies the win98, the drivers and the tools folders from your windows cd to c:\windows\cab

Windows 2000 and xp copies what is needed for you.

Once you have done this and referenced it a few times you should be Jake.

Good Luck Lee

This discussion is closed to new replies.