11 replies
by midgetdoggy Accepted solution
by mjd420nova Accepted solution
by midgetdoggy Accepted solution
by thumbsup2 Accepted solution
Are you saying that you can't get into the BIOS and see them on the screen? Can you see anything on the screen? The little green/blue light coming on just means that it senses that it's connected. Doesn't mean the computer is actually starting. I'm confused about what it is that you're saying.
As previously stated though, yes, you're probably under powered.
by midgetdoggy Accepted solution
by mjd420nova Accepted solution
by .martin. Accepted solution
you could have my problem if turning off the onboard video doesn't do anything...
if it boots up normally with the onboard video, you turn onboard video off, and you still can not get it to boot, your problem my be dead (or dieing) PCI slots :(. and yes this will effect ANY PCI card, with different results, I had a graphics card not boot 19 out of 20 time, but that one time I would get a BSOD. while I had an IDE Raid PCI card which always booted, but then always crashed between windows loading up and five minutes after windows had finished loading.
as for solution??? new motherboard...
by midgetdoggy Accepted solution
by thechas Accepted solution
First off, I do think that your power supply is too small. I don't even look at power supplies rated for less than 500 watts anymore.
Consider that if you are building up a system with a high power video card, the other components are apt to be power hungry.
That said, if there is a problem with the power supply being loaded down, the health monitor section of the BIOS should be shutting the system down or at least giving a warning.
So, while your power supply is under-rated, it is most likely not why the system does not boot.
Keep in mind however that an under sized power supply is the easiest way to damage the rest of the components of your new system.
As to your no post situation, start by checking the clear CMOS jumper on the motherboard. If that is in the normal position, then:
Disconnect or remove as much hardware as you can. Have no drives, plug-in cards (other than video) and minimum RAM.
If it still does not POST, verify that the CPU fan is plugged into the correct connector. Double check all configuration jumpers on the motherboard. Make sure that ALL motherboard power connections are plugged in. Most modern motherboards use both a 24 pin main power connector and a 4 or 6 pin secondary power connector.
Also check for extra power connectors on your video card.
Still no POST?
Well, try a bigger supply. Check that the CPU is properly seated.
Remove the motherboard from the case and make sure that there are no support posts that could make contact to active circuits.
Still no POST?
Now it's time to find a comparable system and see if the CPU and RAM are any good.
Chas
One more thing, check the line voltage switch on the power supply and make sure it is set for the correct line voltage.
by midgetdoggy Accepted solution
by midgetdoggy Accepted solution
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending