Discussion Locked

Cannot boot computer

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi

A Win98SE machine on my network won't boot. Here's what's happened:

I ran msconfig and deselected all Iomega entries on the startup tab (the machine used to have an external Zip drive attached). Next I rebooted and the display got as far as loading the cd-rom driver then froze with a fast-flashing cursor in the bottom left of the screen. I rebooted to Safe Mode and ran Scandisk which did not detect any errors.

Next I booted into Safe Mode and removed each Iomega program entry fromthe Add/Remove Programs applet in Control Panel, rebooting each time, each time having to restart and select Safe Mode. Next I tried to boot to a Command Prompt without success.

Next I booted from a startup disk and ran Scanreg /fix, which successfully rebuilt the registry, but I still could not boot normally.

Does anyone have any ideas?

11 replies

by earnest

Sounds like when you were in Msconfig you may have stopped a video driver. I can't thnk of anything else that would stop it booting normal but let it go in safe mode.Not Booting to command prompt does sound fishey. In anycase I
would go back to msconfig and look at any boxes not checked. Also go to Device Manager and check for devices not working properly. Unless you were using a third party for some other device which you deleted...

Something else you could do was use bootlog.txt to findwhich driver failed.

Load drivers from F8 option and see which failed.

by thechas

Since you can boot into safe mode, I also suspect a driver problem.

I however think that you have a problem with a legacy driver for the Zip drive.

Run sysedit, and verify that there are no lines in these files that reference IO Mega.

I would go so far as to backup autoexec.bat and config.sys then replace them with blank files.
(Windows 98 only needs commands in these files for DOS mode device support.)

Chas

by blackcurrant

Thanks for answers 1 and 2. Further developments:

Booted from a startup disk and ran Norton Disk Doctor with a thorough surface check - no problems. Rebooted and selected 'Step by step confirmation', answered 'Yes' to all prompts and the system started normally. Started Device Manager and removed the SCSI interface for the Zip drive. Rebooted and the system froze after loading the CD-ROM drivers. Checked BOOTLOG.TXT and discovered that the system was failing to load drvspace.sys. Should I extract drvspace.bin and replace the current file, or is there anything else I can do?

Any ideas?

by mzy

Hi, if you don't mind backing up your computer, a quick and clean reinstalling of your OS can work fine. Or else, you could try instead to remove the driver itself, not just the msconfig loading of the driver.

If drvspace isn't loading then yes, most likely you gotta prob with the driver. Remove it.

Hope this helps!

by blackcurrant

Hi mzy, thanks for answering. I will only reinstall as a last resort. I have tried extracting a fresh copy of drvspace.sys from the installation disk and rebooting, but this did not help.

by pctech26

Boot in safe mode once again and run msconfig again.

Select "Normal Startup - load all device drivers and services"

by blackcurrant

Hi, thanks for answering. I have already tried this without success. I think that something other than what has been described above has caused this problem-plus I have spent long enough troubleshooting it. I shall cut my losses and reformat and reinstall.

This discussion is closed to new replies.