Discussion Locked

Can't install 98 over NTFS drive

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I just inherited a refurbished Dimension for my classroom, and when it started tp boot up, it gave me the message that there was no operationg system. I then used a Win98 boot disk to begin to load one on. After performing Scandisk, I received the message "Can't create temporary directory. If you have HPFS or NTFS installed on your hard drive, create MS-DOS boot partition to set up Windows."
How would I go about doing this? A simple format will not work.

3 replies

by thechas

You need to run fdisk.

Caution: Deleting partitions removes ALL information from the hard drive.
Make sure that you have any critical files and information backed up.

Boot from the W98 startup disk.

At the DOS prompt, run fdisk
If the drive is over 2GB, answer yes to enable large hard drive support.

From the main menu, select delete, and delete the NON-DOS partition.

Exit fdisk and reboot the PC.

Run fdisk again, and set up the partitions as desired.
Make sure that the primary DOS partition is set as active.

If you decide to have an extended DOS partition, define the logical drives.

Exit fdisk and re-boot again.

Format at least the C: drive.
If you use the /s switch, the hard drive will be bootable.

For more information, check out the partition planning article at www.aumha.org

There are links to tutorials on fdisk at www.fdisk.com/fdisk

Chas

by tech_wiz03

use fdisk /mbr first
next set-up your partitions with fdisk
then you can format partitions with format
and finally install the op system

regards
rick

by bschwerdt

Try running FDISK and formatting from a W98 start disk, then try loading the W98 OS.

Good luck.

This discussion is closed to new replies.