12 replies
by jsputer84 Accepted solution
by rob kuhn Accepted solution
Most of the current Netgear devices have a setting that either allows or disallows a ping response; though I believe that is only for the WAN port.
How do you have the Netgear connected? In other words do you have the WAN or LAN port connected to your Buffalo? And just out of curiosity, why do you have two routers on this particular network?
by jsputer84 Accepted solution
by rob kuhn Accepted solution
Forget using the WAN port on the Netgear. Connect just one of the LAN ports to the Buffalo. You are basically using the Netgear as a "dumb" switch and so you won't be able to ping the Netgear as the static IP only applies to the WAN port.
The only reason I would use the WAN port on the Netgear in your configuration is if I wanted to setup two seperate LANs (a sort of VLAN).
by jsputer84 Accepted solution
by rob kuhn Accepted solution
Correct. LAN-to-LAN. Before you do that, disable the DHCP service, you've already disabled the wireless, and any other configuration you made have made.
The static IP you assigned should not cause a problem and you could leave it. That would in a sense make the WAN port a "service port" :)
If you really want to make this easier and less of a headache, pick up a small 5 or 8 port 10/100/1000MB Ethernet switch and just remove the Netgear from the picture all together. :)
by robo_dev Accepted solution
Either thru a setting, such as Mr. Kuhn noted above, or with a specific firewall rule.
Enable "Respond to Ping On Internet Port"
I won't mention that having a router-behind-a-router is generally a bad idea and slows down the network. I also won't mention that if you just disable DHCP and hook a LAN port from the Netgear to the Buffalo, you will be able to ping.
by jsputer84 Accepted solution
by rob kuhn Accepted solution
by jsputer84 Accepted solution
by rob kuhn Accepted solution
by who am i really Accepted solution
not familiar with either unit
but somewhere in the config pages should be a setting that changes the unit into a router/smart switch vs, Gateway
Cisco / Linksys units call it (Router / Gateway)
which is weird but,
Gateway Mode is used if your Cisco / Linksys router is hosting your network's connection to the Internet.
Router Mode should be selected if the router exists on a network with other routers.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending