Windows Forum

Ask something
Discussion Locked

Cold Fusion

0 helpful
5 replies

by triniman

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I upgraded a Compaq Proliant 2500 replacing and adding a second CPU- both at p2 333 -- and upped memory to 512mb. Uptomp was run but now "Cold Fusion 4.5" hangs. Three times yesterday. Restarting the service is OK for a while. Any ideas.

5 replies

by ruturaj

If cold fusion is anything like Metaframe You might have to reinstall it because these products pickup the hardware config during install & remain rigid thereafter (they are flexible about memory but not the second CPU)
Regards,

by garetjax

Some additional advice: Run the Compaq SSD for NT (current v2.18) to update your Proliant 2500 HAL (and other Compaq drivers). The uptomp tool is sometimes a little eratic.

I would also evaluate a reinstall of ColdFusion over the top of the existing install. CF may have some SMP-specific DLLs.

Good luck...

This discussion is closed to new replies.