Discussion Locked

Com1 isn't working

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a DOS application in Windows 2000 Pro that uses a modem to transmit data. The problem I'm having is that on the DOS application it only uses COM1 and COM2 for the modem. But when I install the modem it goes to COM3. I try to assign it to go to COM1 but it says that it's in use. But I don't have anything using COM1. When I force it to go to COM1 works fine but after I reboot the PC it stops working. It will says no such file COM1 exists. Can any one help me?

1 reply

by thechas

I assume that you are using an internal modem.

The only way to force Windows to use COM 1 for an internal modem is to disable the COM 1 port in BIOS settings. (or, set the COM port to COM 3 if that is an option in BIOS settings)

Remove COM 1 from device manager before you disable it in BIOS settings.

The modem should then be able to use COM 1 without resetting to COM 3.

Worst case, install an external serial modem onto COM 1.

Chas

This discussion is closed to new replies.