Networks

Ask something
Question Locked

Configuring Ports on HP Procurve using Telnet

0 helpful
2 replies

by scott_langshaw2

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello

I am pretty new to configuring HP Procurve switches as i am used to Cisco switches. I want to extended a vlan to some more ports but cannot figure out how to do it.

I can telnet into the switch but i dont know the commands on how to change the vlan to use which ports.

Can anyone point me in the right direction

Thanks

Scott

2 replies

by jon

Config term vlan ID#

name VLAN NAME

ip address XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX

tagged 1(one port) or 1-24(port range) OR
untagged 1(one port) or 1-24(port range)

This discussion is closed to new replies.