Discussion Locked

Connect to server through specific port.

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I need to remotely access a server through a specific port using terminal services so that I could administer it but I can't find a way to enter any port info. I have set my firewall to accept a specific port only for this server

9 replies

by joseph moore

I don't think you can change the port (TCP port 3389) that TS listens on. That is why you can't find a port setting.

My only suggestion is to run a port redirector program like FPIPE from Foundstone. FPIPE "Command line port redirector for NT/2000. Now with UDP piping capability. Only port redirector we know of that can bind to a static port to bypass firewalls." as their website says.

You could run FPIPE on the open port you have on your system, and have it redirect to 3389 for TS. That way you could accomplish what you want to do.

Go here for info on FPIPE:

http://tinyurl.com/g3xk

PS: it is a free tool!

hope this helps

by whatme?

tried this but couldn't get it to work right...probably my fault but I would have to write a script or somethbing to use it all the time

by cg it

The server uses PPTP or L2TP for remote remote access [unless you use a dial up]. These protocols use specific ports for accepting inbound traffic. PPTP uses TCP/IP port 1723. remote access to a server is defined by the server. you might try the UNCIP & port.

by d.walker5

TS operates over TCP port 3389. If a firewall is protecting the server to which you want to connect, that firewall must permit inbound connections to the server's port 3389. If you are running a client from behind a firewall, that client firewall must premit outbound connections to TCP port 3389.

If this doesn't solve the problem, than rescheck that TS is installed, in the Administration mode, on the server that you need to contact. Also, check the TS Client is installed on the client you'reusing to connnect to the server. If in doubt, remove and reinstall both.

Check any routers that may be blocking port 3389.

Hope this helps.

by whatme?

This info and the info in the next question did it for me. I was able to change the default port in terminal services for that particular client and it works great.

This discussion is closed to new replies.