Crossover cable

connector#1 connector#2
1 3
2 6
3 1
4 open
5 open
6 2
7 open
8 open

So pin 1 -> pin 3, pin 2 -> pin 6, pin 3 -> pin 1, and pin 6 -> pin 2. The other pins don't matter, but I'd put them straight across if you have the wires.

go to "http://library.cs.tuiasi.ro/hardware/hwb/ca_Ethernet10BaseTCrossover.html"; you will find exactly what you need

Please see:

http://www.2000tutor.com/ubb/Forum25/HTML/000482.html
and
http://www.2000tutor.com/ubb/Forum25/HTML/000466.html

1 - 3
2 - 6
3 - 1
6 - 2

If your using 4 pair wire you can go ahead and use the other 2 pairs but there not needed.
1-3
2-6
3-1
4-4
5-5
6-2
7-7
8-8

Hi!
For a crossover cable the pins must be as follows:
Conn#1 Conn#2
1 -> 3
2 -> 6
3 -> 1
6 -> 2
The order of the pins is left to right seen from above (this side of the connector which doesn't have clipper).
The other pins of the 8-pin connector are not connected.

The following article will explain all you need to know about crossover cables.

http://www.duxcw.com/digest/Howto/network/cable/cable5.htm

Cheers
clover

yes..crimp the cat 5 cable in the seqeunce as follows

end A:
Wht/Grn
Grn
Wht/Orng
Blue
Orng
Wht/Brwn
Brown

end B:
Wht/Orng
Orng
Wht/Grn
Blue
Wht/Blue
Grn
Wht/Brwn
Brown

Just go buy one,

This question was closed by the author