Question Locked

Dell Inspiron 1150 won't boot with power cord attached

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My laptop froze yesterday and when I tried to reboot using the power button and with the power cord attached, all I got was a blinking cursor in upper left corner. When I disconnect the power cord, system boots but I first get blue stop error screen (sometimes the text won't load completely on the screen), then when I re-power up, I get the screen that lets me start Windows in safe mode. Eventually, the battery went dead, so I couldn't try anything else. I figured that the power cord was fried (we tested it with a meter and there's definitely something wrong with it), so I bought a Kensington power cord. Now the battery will charge but I'm still getting the same results with power-up.

Any ideas as to what's going on? I do have an extended warranty that's good for another year, so if push comes to shove, I'll send it to Dell.

Thanks in advance for any insights!

Sue

10 replies

by maniacman

I've seen this happen on some models of laptops when the battery goes dead and the BIOS loses its settings. I'd reset the BIOS to the defaults and see if the problem is resolved. The fact that you are getting a BSOD means that Windows is detecting some hardware change that it's not liking. If you haven't changed any internal hardware components, such as RAM or the actual hard drive, then I'd be fairly confident in saying that something in the BIOS changed.

by sckjgs2005

Thank you for the quick reply. I'll give resetting the BIOS a shot.

Sue

by scott

Hello, I have an Inspiron 1150 with the same problem, wondering if yours is solved? I have noticed that with the speedstep technology, the CPU speed is automatically slowed to 1.66 GHz when running on battery, laptop seems to run longer at lower CPU clock. When plugged in to AC power (CPU running at 2.66 GHz) laptop freezes/BSOD almost right away.

by pfarrell

Scott...

I have an 1150 with the exact same problem as well... I upgraded from a celeron 2.6 to a mobile p4 2.8. With speedstep enabled, runs fine on batter, but bsod's immediately after ac adapter is plugged in. Did you ever solve the problem?

Thanks.

by lucassoler777

I'm currently experiencing the exact same issue. My BIOS is A03, so it probably needs a refresh, but when I try to perform it, I get an error stating that the power cord must be connected to perform the refresh (and when I connect the power cord, it freezes. Any suggestions?

by shhite

Buy a new power cord and then try it.

by vishal.visualinsanity

It seems that th issue wat you are facing is with motherboard, get in touch with dell, & if ur sys is under warranty, they will go ahead & replace the motherboard & powercord with Ac adapter. It seems to be a h/w issue, as u mentioned, after disconnecting the powercord, you are able to boot to windows, Also make sure you have taken a databackup before you call up DELL.

This discussion is closed to new replies.