Discussion Locked

dial up connection sharing

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i was wondering how would i share a dial up connection between a windows 2000 desktop and a windows 98 desktop and what are the steps to make this work.. thank yuo

2 replies

by jwilczyn

Set 192.168.0.1 with subnet 255.255.255.0 for your W2K desktop.
Enable ICS on your W2K
Enable - on clients (Win98)
Set proxy (Win98 - IE properties) 192.168.0.1
Your W2K with ICS enabled will work as DHCP server and assign addresses to all clients (Win98)

by thechas

You need some form of network connection between the 2 PCs.

For just 2 PCs, you can use network cards and a cross-over cable.

If the PCs are too far apart for a cable run, and you don't want to run new wire, you can use either power-line or phone-line networking.
Check out www.homepna.org for more information.

Once you have a network set up, set up Internet Connection Sharing:

Enable ICS on the W2K box.

At the end of the process, you will be asked if you wish to create a setup disk. Answer yes and insert a floppy.

Take the floppy to your W98 box, and set it up as a client.

Here are links to 2 Tech Republic articles on ICS:

http://tinyurl.com/hmmg

http://tinyurl.com/hmmi

Chas

This discussion is closed to new replies.