Question Locked

External USB Hard disk not recognised(Tried a lot and Desperate)

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

HI all;

I bought a HDD enclosure with double USB connecter certified for USB 2.0 from an online shop.I put in the 2.5" HDD and connected it to the USB port and it said not recognised disk.I then read through some forums and some one suggested disabling the standard "Enchanced PCI to USB host controller" in Device Manager.I did it an the drive immediately came up in 'My computer' and was working fine.But the transfer rate was slow.After some reading it was clear that disabling the Enchanced PCI to USB host controller" meant making it USB 1.0 and was slow.Anyway it was working for sometime.I ejected it and in the end it said safe to remove and I did take it out.After some time windows said "Delayed writing error $MBR"(smthng similar to it) and it has never been working again:(

Computer
-AMD Athlon 3500+
-A8N SLI Deluxe
-HDD 250GB(WD)
--Windows XP SP2
All drivers updated and services like Logic

After connection a unknown device is shown in deivce manager.The HD is spinning and the LED also turns on and blinks with various changes made in Device Manager.I checked Disk Management and its not listed there. Theres no jumper which makes it DEVICE0.Its a Hitachi Travel start HTS541616J9AT00 HDD 160GB.

Any ideas are welcome.Thanks in advance.

5 replies

by hal 9000

Quite Often with NB's the USB ports run at a minimum Power Output so you need two USB Ports connected to the Drive to allow it to work correctly.

This depends on the M'Board being used but if the HDD isn't recognised with 1 USB Plug the middle one plug in the other one as it is just a Power Lead with no Data Transfer Wires included and is there to provide extra power for the USB Drive.

Col

by angamaly_noble

Hi HAL 9000;
Thnx for the reply.I did try wit with all sorts of combinations,one ,two USB ports in front,in back etc etc.It shows the new USB device found and is installed as unknown hardware.Its ther in device manager as unknown device.Uninstalling and refreshin it brings the same set.Wht puzzles me is tht it worked for smtime after disabling the PCI to USB in Device manager BUT then after reboot is unknown device till now.

by angamaly_noble

After trying all the things tht were mentioned here and other forums and it still didnt work,I came to the conclusion tht the case might be faulty.I tested the HDD with a friends laptop and then found tht it was working well.So the case seemed damaged.I returned it and bought an aluminium case which seemed tougher.It works perfectly now.

Thanks for all those who helped

Have a nice day and Regards
Paul

This discussion is closed to new replies.