Discussion Locked

Faster and cheap heavy duty printer

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

1) We have Heavy Duty HPLaserjet5000N printer installed. Problem is that sleeve of it?s fuser assembly gets damaged/burnt after few months(2-3).And we have to replace it.Can u guess the cause of this and tell us precautionary measure for this?
2) 2ndly What heavy duty printer will u suggest for the circumstances of
a) text printing.
b) High speed needed.
c) Finance is a concern.
d) Is line printer suited for these conditions.
3) Line printer is suited for which conditions?

7 replies

by ann777

We'd need to know approx. how many pages per month you are doing in order to come close to an appropirate response to these questions.

2-3 months of fuser use is unacceptable unless you are doing in the neighborhood of 100,000 pages per month.A new fuser should last 250,000 pages on this printer and if you need another after 2-3 months (and your page count is no where near this amount), then I'd recommend you take the fuser back to the place of purchase and showing proof of purchase, geta new one under warranty -- alone with page counts sheets both when installed and now.

by shiny_topadm

First, I agree with Anna777 that the fuser should not need replacement unless you have an unusually high page count. To accurately recommend anything, we need to define your requirements for monthly volume and "high speed". Generally, these thingscome at a price that's usually high. Laser printers, even high-volume ones, aren't the best for continuous printing. There are some other technologies that don't use heat to fuse ("ion-deposition", for example) that might be applicable, but they are generally more expensive. The traditional "line printer" is usually for "tractor-feed" continuous forms, not cut-sheets like a laser. Once again, let's define your needs...let us know and we might have some suggestions.
---Will

by thechas

It sounds like you need to take a look at OCe' or some other high volume printer / copier solution.

If the printer does have a reasonable amount of idle time, I would consider adding an AC line conditioner.
The only things other than high printer usage that could cause premature fuser burn-out is heat or AC line spikes.

Make sure there is sufficient airflow available in the area of the printer, and that there is at least 6" of free space on all sides.

Chas

This discussion is closed to new replies.