Discussion Locked

Fault tolerance (Mirror Breaking)

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi

Can anyone help me. I have 3 NT Servers and must break the mirrors / parity, problem is when I go to disk administrator the Fault Tolerance Menu is missing and if I have a look at the status of the disks it says Fault Tolerant = Yes. Any suggestions.......

2 replies

by vjohnmoses

remove the second harddisk boot through nt boot floppies edit file boot.sys change the path of the boot divice to your present drive letter
and boot the system with the same drive

by joshg

Unplug the mirror drive and plug it into another controller or change the SCSI ID of the drive. This will break the mirror.

This discussion is closed to new replies.