Discussion Locked

Formatting floppies

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When I attempt to use my A: drive I get a message that the floppy needs to be formatted. I have tried using new floppys that have been formatted when I pull them out of the box. Changed drivers-still the same problem. Any help.

8 replies

by sfc_gijoe

First check to see if any thing is stuck in the drive. I have seem labels and small post-Its in drives before. Then make sure the cable and power are hooked up. Make sure the drive isn't screwed into the bay to tight. If you use a power screwdriver you can warp the drive bt over tightening. If none of that works then replace the drive.

by sfc_gijoe

First check to see if any thing is stuck in the drive. I have seem labels and small post-Its in drives before. Then make sure the cable and power are hooked up. Make sure the drive isn't screwed into the bay to tight. If you use a power screwdriver you can warp the drive by over tightening. If none of that works then replace the drive.

by fred07

Hi,
Your floppy cable is loose or bad or your floppy is bad.
Also check the megs of the disks you are using as there are old 1.2 and 1 meg floppys being sold out there by many "not aware" stores.
Also when dealing with critical data backups such as Quick Books Pro you should always do a full format not quick erase.
Hope this helps you,
fred

by tpengill

Check that you did not buy floppies that are pre-formatted for mac. Put the floppy in the drive and right click on your A: drive and select format and do a full format not quick. Try a floppy in the drive that has something on it to see if you can read the files. If you can then your drive is ok and the floppies are bad. If this doesn't work go to control panel then system then hardware and device manager. right click on your floppy and select uninstall. Reboot and it should reinstall if it's working ok.

This discussion is closed to new replies.