Question Locked

Hard Drive Power plug pins

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I recently upgraded my P.C. and installed a new drive.When I disconnected the old drive two of the power pins pulled out of the drive with the
power cable.how can I get power to the drive so I I can transfer my files? R Beeman Atlanta,IN

3 replies

by mjd420nova

The pins could be soldered back onto the board. Or if the pins are broken, your local electronics store should have replacements. Be careful and check to be sure the traces on the board are still intact. If the traces have been lifted or have a gap in them, some small gauge wire can be used to patch them and a little hot glue would help to hold down any loose traces.

by hal 9000

What you need to do is replace the pins and with an Earthed Tip Electronics Soldering Iron and some Silver Solder and very carefully solder these pins back on.

If you don't have the necessary skills or tools you can always buy the same model HDD on E-Bay or some place similar and change the circuit board over so that you can access your data. You may need to buy a special Tamper Proof Torx Driver but it's quite easy to change the circuit boards over if necessary.

Col

This discussion is closed to new replies.