Discussion Locked

HARDDRIVE

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do i Format a Slave Harddrive in WINDOWS XP

3 replies

by thechas

Before you can format a new drive, you need to partition the drive.

Go to Administrative tools, Computer management.
Click on disk manager.

Right click on the drive, and set up the partitions as desired.

After the drive is partitioned, right click on it again, and select format.

Chas

by dmiles

Note that menu option 5 is available only if you have two physical hard disks on your computer.
Press 5, and then press ENTER. When you do this, the selection changes from the physical disk 1 (master) to the physical disk 2 (slave).
Press 1 to select the Create DOS partition or Logical DOS Drive menu option, press ENTER, press 2 to select the Create Extended DOS Partition menu option, and then press ENTER. When you make your slave drive an extended MS-DOS partition, your drive letters does not change. For example, if the first drive contains partition C and partition D, your slave drive becomes D unless you set the slave drive as an extended partition. If you skip this step and just create another primary MS-DOS partition for the slave drive, the new drive becomes drive D and what used to be drive D, changes to drive E.
You can partition the slave drive to make other logical drives just as you did with the original master drive. If your computer cannot detect the new drive, you may need to add the following line to your Config.sys file, where drive is a letter that is greater than the last drive letter on the computer (including the CD-ROM drive):
lastdrive=drive

How to Format a Slave Hard Disk
To format your new partition or partitions, use one of the following methods, depending on your file system. For a FAT16 file system:
Double-click My Computer, right-click the partition that you just created, click Format, click Full, and then click Start.
After the format procedure is complete, click OK to close the dialog box.
For a FAT32 file system:
Click Start, point to Programs, point to Accessories, point to System Tools, click Drive Converter (FAT32), and then click Next.
In the Drives box, click the drive that you want to convert to the FAT32 file system.
Click Next, and then click OK.
Click Next, click Next, and then click Next again.
When the conversion procedure is finished, click Finish.

This discussion is closed to new replies.