Question Locked

HELP! Monitor = 'No Signal' (tried everything I know...)

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Bought a new Viewsonic monitor -

(ViewSonic Optiquest Series Q20WB Black 20" 5ms DVI Widescreen LCD Monitor )

----> ERROR: 'No Signal'

What I have **already tried and has not fixed** my problem:

1). reseated all cards & RAM
2). removed all cards one by one and rebooted in between each removal.
3). tried 2 seperate 350 watt power supplies.
4). tried 4 seperate video cards (GeForce 6800 GT, Radeon 800 Pro, 2x Radeon X800 XL's...all seemed to be getting power w/ fans running properly).
5). Swapped out processors and back
6). Tried hooking up monitor to another PC and it worked fine.
7). tried hooking up an older monitor I previously used on this same machine and same result: not working.
8). tried hooking up monitor to both connectors on video cards.
9). disconnected hard drive during most of these processes.
10). Swapped out one Nforce 2 MSI MB for another Nforce 2 (MSI also).

I had no Motherboard beeps during these processes.

I don't know what else I can try. Not really a hardware guy. =P

Any constructive suggestions?

I read a bit about people owning MSI boards having similar problems but it would be unusual for two boards to not work....granted they are both older boards....

Only other thing I can think of is swapping out the RAM and seeing how it acts.

I do not believe the PC is booting to Windows XP while the monitor is off.

6 replies

by captbilly1eye

It appears that you were very thorough in your troubleshooting.
I was just wondering... did you try a different connection cable?
Use the cable you used to connect the monitor to the other system.
It wasn't clear if that had been tried.
Just a thought.

by timbrewolf

Did you have this monitor on the system or is it a new monitor?

Did you have a different monitor working on this system configuration before?

Could be an issue caused by the refresh rate being out of range, but most ViewSonic LCDs will tell you that's the issue and you should still be able to view it in POST.

If you're not getting POST, and no beeps, and the fans are working - it may not be the monitor working, it may be the system not actually booting up properly.

I had an issue like this previously and it was related to a badly abused case touching the motherboard and causing a short. Look for any motherboard contacts touching the metal case, as this is normally the sign of an electrical issue more than a monitor issue.

by mark_median

Will try these later this evening or tomorrow.

The monitor *Does* work with another PC I have built and I used the same cables when hooking it up to two different PC's. Worked on one, not the other. The PC it's not working on is a slightly older motherboard & processor. I was using the case it's in prior to connecting it to this monitor and it was working fine with another Viewsonic monitor I had although it was a CRT. Now it works with none of my monitors.

I haven't tried different RAM yet, and I supsect I may not have been careful enough when handling both MSI MB's.

I will keep checking back and will post my solutions (if any) when I have tried the above suggestions.

by ic-it

I've occassionaly seen these symptoms because of a bad CPU. If you have a compatible CPU swapp it out. Be sure to use a thermal compound and the fan.

This discussion is closed to new replies.