Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Tz 210 wireless-N, it was working fine. but now when ever i connect to the LAN default port the X0 link/spd LED turns into red. when i try to reset entering the IP address takes me to the SafeMode. i can connect to the internet from another port assigned as LAN but i can never access the router by 192.168.168.168. knowing the Test LED blinks but not continuously. please help
3 replies
by dima1 Accepted solution
Clarifications
by peconet tietokoneet Accepted solution
Keep everything attached to your SonicWALL TZ 210 appliance, now switch the SonicWALL TZ 210 appliance OFF. Wait 5 seconds then switch back on again. Attach your laptop or desktop computer to the port "X0 link" and follow the info above. After it comes back on line you should be able to access the router ip address as stated.
Please post back if all goes well or not.
by dima1 Accepted solution
thanks a lot for replying, i still dont understand what went wrong. but what i did was disconnect everything including the power supply and while holding the reset i connected the power supply .. took me back to safemode again and i was able to use the firmware
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies