6 replies
by stein_brian Accepted solution
by jpelectron Accepted solution
Cisco ASA does not do load balancing, only fail-over to a second ISP.
Look into Peplink or another multi-wan router that supports load balancing. You would put this device between your ASA and your ISP(s). Be aware that load balancing can be a headache and mess up certain applications, which you then must build rules for so these applications favor or only use one ISP. Your much better off getting a bigger pipe from just one ISP in my opinion.
If you want the "student" or wireless network to exclusively use one ISP, and the "staff" or internal network to use another ISP, then this can be done within the ASA, assuming you have the appropriate license for multiple (4) interfaces.
by stein_brian Accepted solution
by jpelectron Accepted solution
If you do a "show run" on your ASA it will show you what features your licensed for. Base license usually means 2 interfaces, 0/0 as the outside and 0/1 as the inside, it may not let you pass any traffic on 0/2 or 0/3. Security Plus license has no restriction, so you could do something like this...
Eth0/0 WAN
Eth0/1 internal LAN
Eth0/2 WAN of second ISP
Eth0/3 student LAN and wireless
You would make separate NAT rules so the Eth0/3 LAN is NAT'ed to the Eth0/2 WAN. You likely have Eth0/1 NAT'ed to Eth0/0 already.
You could also put the ASA in a security context mode, where it's a passive device, I've only had a need for this once, the idea is it doesn't need to act as a NAT router, but rather just between your router and ISP(s). This isn't appropriate however if your ASA is being used as a L2L VPN or client VPN endpoint.
I suppose you could have another physical firewall with a different default gateway, but now that's more hardware to support.
by robo_dev Accepted solution
if your intent is to keep the WLAN totally separate from the wired lan, you could create VLANs and a separate subnet for wireless users, then provision a FIOS circuit and router/firewall and proxy server for that VLAN. Just like setting up a guest WLAN on any network.
If you had no requirement to do content filtering (which I bet you do), then this would be very simple, but otherwise you will need to add another proxy server to filter WLAN traffic from the other ISP.
If you are not doing content filtering, that may be why your users are using up all your bandwidth :)
My understanding of the ASA is that it does not do policy-based routing, which I believe is what you need to do load-balancing across multiple ISPs.
by stein_brian Accepted solution
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending