7 replies
by jwilli36 Accepted solution
by seanferd Accepted solution
If it is set to DHCP, this will take care of itself. If you are using static addressing, just assign a LAN address in the 2Wire for the Cisco, then assign the same IP to the Cisco's WAN port.
You are going to need to set up bridging on the Cisco router. See router documentation if the interface isn't self-explanatory.
by jwilli36 Accepted solution
by seanferd Accepted solution
Since you are using the others as access points, correct?
They usually offer "bridge" or "WAP/AP mode" terminology for the relevant config.
And how you configure which router depends on whether both are connecting to the 2Wire or if you are daisy-chaining one Cisco to another. Just use the appropriate IP addresses, and don't duplicate any IPs that aren't meant to point to the same device.
by wwgorman Accepted solution
I have Cisco Valet Plus in my office upstairs in a 4500 sq. ft. house with 2/3 of the space on the first floor. For good coverage on the first floor I added a Hawking Technology Hi Gain Wireless G Range Extender on the first floor. On the second floor in my office and in my wife's office down the hall we have 5 bars of signal. Downstairs with the Hawking Extender we have 4 bars of signal. Upstairs we log onto the Valet Plus unit directly and downstairs we log on to the Hawking extender. We have the password for both WPA2 protected devices the same so their is no confusion. The two upstairs units are portables used as desktops and the computer used downstairs is a Netbook moved around to the room where we are for some extended time.
Both the Valet Plus and the Hawking Extender set up time was less than it took to unpack each.
Caution: Do Not Use The Cisco WRE54G Extender unless you want a hobby of trying to make and keep it working.
by wesley.chin Accepted solution
by wwgorman Accepted solution
The normal address for access to the router is 192.168.1.1 however, you have DSL and that is the address for the Modem in that case.
Try 192.168.2.1 for one router and 192.168.2.2 for the other. If that doesn't work try 192.168.3.1 for the second router.
To do this you will need to plug the router directly into your computer from one of the other than WAN slot. For whatever the reason I like slot #2 on routers for this purpose as I was once told this was the "best." Don't ask me why.
There should be no need to log on to AT&T as the DSL line is activated into your house already.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending