Question Locked

how to connect access point to connected router

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
have a d-link router connected to the internet and i have an access point tp-link, i want to make a wireless link from the acces point to the router to make it as a repeater to link it by network cable to another device .

6 replies

by d13thdragon

please read your question and see if we can under stand what you are saying.

by berwin

There's a lot of good information in the previous response, but I think they're talking about the best way to make wireless signals available throughout the house.

From what I'm understanding, you're trying to connect a non-wireless device (dvd streaming) to your wireless network, so you won't have to run cable to another room/floor.

If that's true, you'll need to note the throughput issues d13thdragon brought up.

by d13thdragon

Access points have three modes: Access point, Bridge, and Repeater. Remember wireless is half-duplex with only 20% good-put so you may have a 100mbs wireless this means that upstream is 50mbs and downstream is 50Mbs this equals 10Mbps of actual data the rest is wireless overhead. Now you are adding a repeater in to the mix which will down grade your server to a whopping 2.5Mbps connection of actual data. You are best to wire the access point to the router and treat it like an access point. Put the routers wireless channel on 1,6 11 use these channels only to avoid cross talk so the router is on channel 1 and the access point is on channel 6 use the same SSID and WPA2 shared key on both the router and access point your wireless device will be able to talk to the one with the best signal without having to authenticate. Being that you went as cheap as possible on your equipment without thinking about it. Don???t expect it to work as good as say a Cisco or Belkin device. Throughput on d-link and Netgear are poor even though they say 1000Mbps wired it never is even close to that.

by jasonharri5

First he states that he has a dlink router, in addition to the router he has a tp-link access point. He is asking how does he set up his tp-link access point to be repeat the wireless signal of his router. I believe that d13thdragon has answered this sufficiently though.

This discussion is closed to new replies.