Question Locked

How to hook up an EIDE HD on an ATA System?

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have purchased a new computer, and have my old EIDE HD's from my previous one. Is there any way to hook up the old drives, to transfer data to the new ATA drive?

I have a ton of research, photo's, etc. that I would hate to lose.

Thanks,

4 replies

by ic-it

Open the case, gently remove the cable to the CD or DVD drive and use that. Insure your drive's jumper settings are set properly (should be if you use the end of the ribbon and the drive was the master on the old system).

by rkuhn040172

Then go to the store and buy an external case for the older drive. Maybe cost you $30.

Then, you can connect to the older drive via a USB cable.

by rkuhn040172

They should be compatible.

If what you mean is there is a different pin out, then you should be able to find an adapter at your local PC retailer.

Just make sure you set the master and slave settings correctly.

This discussion is closed to new replies.