Question Locked

Hp pavillion ZE5185 Boots only with Ac Charger

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
ok so my dad and a family friend both have hp laptops with the same problem but for now im using the pavilioon 5185 as reference as my dads is under waranty. me and my dad know a little to some about computers and we cant figure this one out. basically the laptop wont boot just on battery alone. it works only with the ac charger plugged in. the weird thing is the laptop can distinguish whether the battery is present or not. we ran diagnos tests and did other things and it reads the batteries and says they are present but dead but STILL charging yet no charge holds. since the ac power and battery power runs through diff circuits im not aure on how to fix it any help would be great thanks

7 replies

by thechas

The fact the the battery is reported as dead, and does not charge indicates that the battery itself has failed.

The best way to verify that the battery is bad is to take it to a battery shop like Batteries Plus and have them test it.

If the battery tests good, then there is a problem with the charger circuit inside the laptop.

I would all but guarantee that it is the battery and not the charging circuit.

As to the one under warranty, not all warranties cover the battery.

Chas

by tintoman

But I definitely agree here, a new battery is what you need 99% guaranteed

by ninjaofdespair

we tried a diff battery but that one read as dead two will try replacing battery or using a good one and if we use a good battery and then it still wont charge then i assume is the circuit? if turns out to be the circuit whats the best way to go about fixing it?

by thechas

Before we even consider repairing the charging circuit, I need to know what your electronics and mechanical skills are.

Can you tell 1 electrical component from another?

Do you have and know how to use a DMM or oscilloscope to analyze a circuit?

How about soldering skills?
Have you soldered surface mount devices?
Have you removed and soldered components from multi-layer circuit boards?

If you don't have the skills and proper tools, you are going to be money ahead taking the laptop in for service. Without the correct tools, the risk of causing more damage is very high.

Now, what you can do is take a look at the battery contacts.

On the battery, there should be either several flat silver colored metal areas, or perhaps some circular areas with visible metal in them. If any of these is corroded or looks damaged, that is an indication of where the problem is.

Now that you have identified the contacts on the battery, look inside the battery compartment for the mating contacts.

Do these look clean and properly aligned?
If these are bent, broken, or corroded, that could be the problem.

If the contacts in the laptop are bent, great care needs to be used when attempting to straighten them. Bending the metal too fast or too much at once can cause the metal to fracture or break.

As I stated in my first answer, I would take the battery to a shop that actually services batteries. They should be able to charge and test the battery to verify if the battery is bad. All it takes is 1 or 2 dead cells in a pack to drop the voltage below the power up level.

Chas

by ninjaofdespair

yeaqh i have most of those skills except for dmm and oscilloscope(only shown once a while back)i do know soldering and surface mount with seriees and parralel circuitry understanding along with knowledge of diff components which in e3lectrical engineering you need to know your capacitors from your resistors lol ok will take the battery to specialist if not take info given by you and head from there thanks very much

This discussion is closed to new replies.