Discussion Locked

I can only see half of the network.

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a NT 4.0 network and one workgroup on the same setup. When I log into the network all of the things that are mapped to the fileserver connects back up just fine. But the other systems in the workgroup cannot be seen. Now if I go to any other system in the workgroup I can see everyone on it including the one that can't see them. I've changed NIC and Cable still no change. Any idea's?

7 replies

by clearsmashdrop

Are you able to ping any of the machines that you cant see?

Did you try right clickining on Network Neighboorhood and choose "Find Computer" then typing in the name of one of the computers you cant see. Sometimes it will show up this way.

Thewindows 98 machine is probably having trouble resolving names. I dont know is you use DNS, WINS, or LMhost files but the two things above will help eliminate physical problems.

by mdavis

Are all computers using the same protocol? If two computers are using different protocols, they won't see each other when browsing. If they are both using the same protocol, such as TCP/IP, make sure that you have the right IP address and subnet mask set. Last, check the bindings on the machine that can't see anyone in the workgroup. If the protocol is bound to the server service, that machine will show up when browsing, but if the protocol is disabled on the workstation service, it won't be able to see other machines on the same network using the same protocol. Good luck.

by nettek

In order for everything to be seen in Network Neighborhood, the Workgroup name must be the same as the Domain name of your NT LAN.

This discussion is closed to new replies.