IBM has an update on this for those of you searching on the web her
https://www-304.ibm.com/systems/support/supportsite.wss/docdisplay?lndocid=MIGR-5073950&brandind=5000020
There is another solution for the HS20, but it is temporary.
Make sure that you power off the blade in question and make sure that it is powered off in the remote control console. Be aware that the power status will still say on, don't worry that is normal since it cannot communicate with the BMC. Just make sure you see the standard "No display" on that particular blade module KVM session.
Grab the latest BMC update for your HS20 blade from IBM. Update the firmware thru the Blade web or console page. Once that upgrades, power on the box again (note you will now see that the device is showing as 'off'). You should be good to go.