Discussion Locked
0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a computer that I was thrown and said "reinstall windows 2000" However there is RAID in the system. I don't know much about it, but I do know I tried to take out the hard drives, and that was a bad idea. I did get them "reset" and reconfigured to let me boot up. However I was then suggested to try to take out all but one of the hard drives and try to install, no luck. Now I can't even it to come back up to the desktop. Can anyone help me? I want to wipe everything clean and restart fresh with windows 2000 server...I know nothing about RAID. Thanks!!
1 reply
by robo_dev
So on most servers, you go into a bios setup of some sort to create/destroy/change the RAID config.
Once you have the RAID configured, from a PC perspective, it should work just like one physical hard drive.
From there the tricky part is that most RAID arrays use some special SCSI disk controller, which is not a standard part of Windows. So after the Windows install CD boots, it prompts you for 'load SCSI drivers'...and that's what you need to do at that point.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies