Discussion Locked

INACCESSIBLE BOOT DEVICE on RAID5 NT SVR

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I received the above message on my server. I have not changed any hardware or software. Using the LAST GOOD did not work-same message. I ran the hardware diagnostics but found nothing wrong. I tried to repair using the NT CD-ROM but it could not seethe hard drive. Bootabel floopy gives same message and I can not get to the hard drive to change any fiels. Any suggestions?

3 replies

by jaystar

This normally happens when the boot.ini file is missing or incorrect. You can use the reference at technet to tyr to figure out what the values should be. This can also happen with servers if you upgrade the firmware on the hardware and not the associate drivers in the OS. For example, I have seen Compaq servers do this when the ROMPaq for the machine was updated, and the compaq agents / drivers were installed, but the RAID controller was an old firmware revision. If that is your situation, then upgrade all firmware to latest versions (the server ROMpaq, and the controller ROMpaq) and it should boot.

by johnny:p

Have you recently enabled/disabed your SCSI BIOS, or changed any other settings via your SCSI setup?

This discussion is closed to new replies.