Discussion Locked

Install win98

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

On a friend's computer for an unknown reason the Win95 registry disappeared. I decided to install Win98. After PnP and non PnP devices detection :
- the computer reboots
- the splash screen appears
- a strange and quite audible CLICK is produced- the splash screen freezes and so the computer
After 3 attempts I went to bed (2 AM) !!
Any ideas are welcome

5 replies

by thechas

Did you format the drive first?

I suspect that you are running into version compatibility problems.

At this point, the 'simple' step to keep the data files intact is to boot from a floppy, and delete the following files:

ALL non-data files in the C: folder
(with any luck, all the files in the C: root are system and not data files)

Then start clearing out the Windows folders and sub-folders.
You can leave files in
Favorites
History
Application data

The files in C:\Windows
Windows\System
Windows\System32
and related sub-folders MUST be deleted.

Keep in mind, that there may be a hardware problem, and that is why the W95 registry was lost.

Make sure that the RAM modules are fully seated, and all plug-in cards are properly seated.

If the problems persist, it may be easier (and cheaper) to get a more powerful used PC and install W98 on it.

Make your friends hard drive a temporary slave drive to recover any data files.

Chas

by Member 36670539

Thanks Chat, in fact I had already followed your suggestions, except delete autoexec.bat and config.sys. I finally solved the problem by REMing unneccesary drivers (sound and CD) and now Win 98 is OK.
Thanks again

by jimmy

First things first.
If it is geting to the PNP screen and freaking out first thing i would do is take all PNP devies off of the PC, I would remove printers, scanners, sound cards etc everything except for the raphics card of course.
I would suspect it could HW fault.

This discussion is closed to new replies.