LAPTOPS W/WIN98
I FORGOT MY PASSWORD TO MY LAPTOP AND MY THINGS LOCKED-UP TIGHT...DO I USE THE SAME PROCEDURE ON MY LAPTOP AS I WOULD MY DESKTOP?
WHERE'S MY JUMPER LOCATED ON MY LAPTOP IBM THINKPAD 390E
Windows Forum
I FORGOT MY PASSWORD TO MY LAPTOP AND MY THINGS LOCKED-UP TIGHT...DO I USE THE SAME PROCEDURE ON MY LAPTOP AS I WOULD MY DESKTOP?
WHERE'S MY JUMPER LOCATED ON MY LAPTOP IBM THINKPAD 390E
by oz_media
IBM and password recovery. As for jumping the CMOS, IBM has complete parts replacement manuals on thier website. I got one for my R31 and it covers EVERTHING for removal and replacement in the field by thier techs. If you can't find one on thier site for your notebook, they WILL send you a link if you email them.
Is it your BIOS password or the Windows password?
What OS is it?
NOTEL If it is your BIOS password, th edafault codes no longer work but if you have an older notebook try here, http://www.labmice.net/articles/BIOS_hack.htm
If you have a newer IBM with a lost BIOS password, IBM will have to FLASH it for you.
If it is an admin or user password you need, supply an OS and I'll try to help further.
by oz_media
by timwalsh
It depends on which password you forgot, as there are three that can be implemented.
If you just forgot the Power-on password, you are in luck. There is no jumper. You must remove AC power, remove the laptop battery, and then remove the backup battery (look in your user's manual for the location) for 20 minutes. Replace the backup battery, reapply power and boot up. You should not get the password prompt.
If you forgot the Hard Drive or Supervisor password, you may be out of luck. There is no way to reset these passwords. The loss of the HDD password requires that the hard drive be replaced. The loss of the Supervisor/Setup password requires that the system board e replaced.
Your only other choice would be to buy a replacement BIOS security chip from a company such as PWCrack.com (take a look here - http://www.pwcrack.com/security_chips_ibm.shtml). Such replacement chips require you to use a soldering iron to remove the old chip and install the new one.
This discussion is closed to new replies.
Sort by Trending