Discussion Locked

Mapped drives "x"ed out

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm having a problem with some of my WinXPro machines where the user's network drives are all shown with the red X in Explorer but can be accessed once the user clicks on the drive. Normally, this would not be a problem, but some programs are acting as if the drives are not present due to the red X. Once the user clicks on the drive, the program in question then recognizes it. any help???

5 replies

by dklippert

Glad you asked, it's bothered me too.
There is a timeout in the security settings for mapped drives. It's usually 15 minutes. This is to reduce traffic.

To modify idle time, at a command prompt using:

net config server /autodisconnect: minutes.

For example, to set the Autodisconnect value to 30 minutes, you would run the following command line:

net config server /autodisconnect:30

If you would like to turn Autodisconnect off, do:

net config server /autodisconnect:-1.

Mapped Drive Connection to Network Share May Be Lost 297684
http://tinyurl.com/a3nn

by clt-it_tech

Do I need to do this at command prompt of the server or the individually affected workstations?

by compserv

You cannot map to a computer that is turned off. You must start the computer you are mapping to first, if you do not you will get the red X. You can use a batch file with a net use command in it to map all of your drives after all computers are up and running.
net use f: \\computer1\share1 /y
net use g: \\computer2\share1 /y

by clt-it_tech

Server is the machine being mapped to... it is always on. Maps on my XP workstations are the result of login batch file which uses the "net use". Thanks for trying to help.

This discussion is closed to new replies.