3 replies
by anti_apathetic Accepted solution
by ugadata Accepted solution
I will presume that these are both IDE drives.
If both drives are on the same controller (and there by sharing the same cable) verify the Master/Slave jumper and that the drives are connected on the cable properly according to how the jumpers are set as Master/Slave.
he other option would be to set both drives as Cable Select so you don't have to worry about master/slave and cable positions.
Have you looked under Disk Management to see if both drives show up there? Sometimes Windows tries to assign the same drive letter to more than one storage device and only one of the devices will show up. To resolve this change the drive letter (from Disk Management) for the one not showing up.
by anti_apathetic Accepted solution
I had the jumper on one of the drives set wrong, and never thought to check it. Thanks for the tip. Now... to build a new one!
Thanks a million
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending