Discussion Locked

Mixing wired and wireless networking?

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Is it possible to hook a wireless transmitter to one of the unused output ports of my netgear router? I have a Dell Axium and would like to connect in my home without changing my system to completely wireless.

4 replies

by joseph moore

Yes, you can connect a wireless access point into an existing WAN/LAN wired network structure.
The wireless access point would then allow wireless NICs to connect to the rest of the network.
All you need to make sure is that your wireless accesspoint has a standard RJ-45 Ethernet port that you can plug a normal CAT5 cable into, and the other end of the cable goes into your Netgear router. There should be instructions with the wireless access point on doing this.
It will work just fine.hope this helps

by philthegreat

wireless networking is easier to be interrupted.
Your shaver will affect its ability.
I am not joking, I have just shared it with two professionals in different fields who have the same experience.

So only if you really need it , it is not recommended.

Of course, you can do this kind of networking as the previous answer.

by philthegreat

wireless networking is easier to be interrupted.
Your shaver will affect its ability.
I am not joking, I have just shared it with two professionals in different fields who have the same experience.

So only if you really need it , it is not recommended.

Of course, you can do this kind of networking as the previous answer.

by hjs

One thing I had to do was make two hardware profiles. I thought XP was smart enough to see both a wired and wireless network but it is not. I could not get a laptop to connect via the wireless connection. I had to break down and call tech support. The first thing they asked me was if I had configured it for a wired network and I said that I had. They had me disable the wired network connection and bang off it went. So I just set up a hardware profile for wired and wireless and I works great. hjs

This discussion is closed to new replies.