Discussion Locked

Network Neighborhood Subnet

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have inherited responsibilityfor two remote sites, and would like to be able to control the computers from a third location. In W2K (and NT 4.0) Network Neighborhood I can see all the pc's in my subnet 10.87.xx.xx. I cannot see any pc's in subnet10.87.yy.yy or 10.87.zz.zz. However, I can ping them by IP and name, can run tracert, and can find them all with Neotrace. Using apps like NetOp and RemotelyAnywhere, I cannot see the pc's in those subnets. NetOp t/s tells me they use Windows' browser in their deployment utility to "see" computers, so if Windows doesn't see them, this app won't. Any suggestions would be greatly appreciated!

9 replies

by cul8rm8e

Are these machines logged in locally in a workgroup environment or Domain?
If its a workgroup environment and all machines are part of the same workgroup then there shouldnt be any problem.
If this is a Domain environment which i suspect then you should see all workgroups (subject to IP and Mask) through My Network Places.ENTIRE NETWORK!
My first thought is that DNS (forward and reverse lookup)seems to be ok,and maybe your logged on locally which you will only see any machines in that local WORGROUP
Do you have this problem browsing Network Neighbourhood or Network Places from either or both Win2k and NT4 machines?

give us a bit more info nd im sure we can be of more help to you.

by cruffin

Turned out to be multiple problems. Resolution was to set up a WINS server at each site with each configured as its own primary and secondary. After 72 hours (???) everyone could browse everyone else.

by ctmoore1998

My guess is that your separate networks are connected by routers if that is the case and your workstation has a static IP then you should be able to create a access-list to allow your ip access to the other networks. The other option would be to change your subnet to something like 10.0.0.0 255.255.252.0 this would make your network 10.0.0-4.0 all one big network allowing access to all computers accross the board. This will have an effect on the network performance. So I suggest solution 1. Consult you router config guide if it is CISCO update this ? and I'll try and work up a couple of example lists.

by joseph moore

To me it is sounding like a firewall issue. Something is filtering the connectivity between your network and these others. It could very well be a firewall. It is possible to configure a firewall to let ICMP packets through -- which is what you are sending when you PING someone -- but block TCP/UDP port connectivity. So, check on the network and see if firewalls are used.
If not, then the routers at the remote networks could have access lists that are blocking port connectivity also. You need to check on that.

Try this: click Start -> Run and type in \\ followed by the IP address of one of the Windows machines in a remote network. \\192.168.1.1
Something out there in one of the remote networks. See if it opens anything up for you, orif it fails.

Let's start there.

This discussion is closed to new replies.