Windows Forum

Ask something
Discussion Locked

No Banners please

0 helpful
6 replies

by mickrose7

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
NT4 over Netware network printing banners have been disabled but banners still print how can I stop this.

6 replies

by dcassat

Assuming that you have clients with Client32 on them and are printing from a DOS program: You must disable them by the Capture command such as: capture l=2 nff nb nt ti=5 (nb=no banners). DOS programs only understand the DOS capture command. You should put the Capture command in a login script but you can put in a batch file if needed and launch it from an icon on your desktop.

Assuming that you are printing from a Windows program, you would have to go into the client 32 settings and disable the print banner but it sounds like you've done this.

I've worked with this problem A LOT so if this isn't the answer please give me more info and I'll help.

by tbradley

Under Printer, properties, general, have you turned off separator page ( set to none )?

by msgtray

Had this problem once and found that it was a (documented) flaw in NT SP5. What service pack are you on? Upgrade to SP6a and observe the settings as suggested in the other answers. Ray

by ashepp666

Are you using Gateway Service for Netware if so on NT station check settings in GSNW located in control panel.

This discussion is closed to new replies.