Discussion Locked

non system disk

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
seems like my disk controller files were corrupted i can't get past tis message no matter what i do. I am running os win 98 on a compaq 5635 I have pulled all cards except the video card and all extra memory out. I don't get any responce from compaqsupport anymore. Thanks for any help.

10 replies

by thechas

The hard drive lost a couple of files that are required to make it a 'boot-able' disk.

If you can boot from a W98 startup disk, type
sys C: from the DOS prompt.

The hard drive will now be a boot-able system disk.

Chas

by yeswings

It does not recognise the start up disk I get an IO error when i put it in the floppy. The hard drive is a big foot it does not fit any of my other pc's

by ann777

If the first answer fails to help, the hdd may have crashed. You may have to replace that drive.

by ann777

Place the dirve on another computer (change jumpers to secondary) and see if you can even access the files on it.

by thechas

If you have a spare IDE channel on one of the PCs, you can set the big-foot on a book or bax, and just run the wires out from the side of the case.

For temporary use, I have even layed drives in the bottom of the case.
(Clean out the dust first)

Chas

by bjorndahlen

OK,
what's the status of the drive in the bios ?
Also, can you see any disk parameters on the
label of the drive C/H/S and/or size ?

Since you have a compaq, probably hitting
f10 during startup will get you into the
bios setup program.
Compaqs are kinda funny in that they usually
store the setup program on a hidden partition
on your hard disk. If that partition is ok,
you should see a white square in the upper right corner, at which time you hit f10.

This discussion is closed to new replies.