7 replies
by sigmapi71
Start your machine from NT4 Setup CD. When asked press R to repair the existing installation.
Hope this helps.
by ping.perez
by zaheerahmed2
OK before u try repair try recovery console or in safe mode tray chkntfs which will check your hard drive for any errors. If this does not work then try http://searchwin2000.techtarget.com/tip/1,289483,sid1_gci862874,00.html
this article should help.
http://www.windowsitlibrary.com/Content/329/25/4.html
hope the articles help
by ping.perez
by tduval
HAL means Hardware Abstraction Layer.
So if it's dead, your computer too.
Try to boot with "last good known configuration", even with VGA. If nothing helps, your OS is dead.
You could re-install, but it's hazardous.
If you don't have any backup, try to plug your disk as a slave in a new computer, and copy datas.
by ping.perez
by ping.perez
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending