Question Locked

PC wont boot with wireless network adapter plugged in

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Recently I got up to find my computer had crashed. I restarted it and it would not boot up. the monitor sometimes would not come on and other times it would but then would restart before windows loaded.

After lots of experimenting I found it was the wireless network adapter that was causing the problem and when that was removed everything worked fine.

I uninstalled the wireless adapter and installed it again but as soon as I plug it in to the usb socket the computer restarts then wont boot up until I remove the adapter.

In the end I decided to re-format the hard drive and install a fresh version of windows and was sure this would fix it but it has not.
I still have the same problem of PC restarting as soon as I plug in the wireless adapter.

Earlier today I downloaded the latest BIOS software from the motherboard manufacturers website and installed that but that also did not solve the problem and I am now out of ideas.

If anyone has any suggestions I would be very grateful to hear them.

Thank you, Michael

4 replies

by wtlco

suggest: you reset your firewall setting-or-check selection of youjr internet security-keeping at custom level. Good Luck

by mjd420nova

This sounds like the USB driver chio that supplies power to external device via the USB port has gone bad. The port is being drained when something is plugged in.

by michael.g.bradshaw

Thank you for the two replies I have had so far.
The answer from mjd420nova sounds as if it could be right. What would I have to do to solve this? Is it possible to get a new USB driver chip?

This discussion is closed to new replies.