Discussion Locked

"Press F1 to enter Setup" msg upon boot?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm about to go to a co-workers house to help her figure out why she gets this message every time she boots up her PC. (actually, once in a great while the message won't appear) Because I haven't seen it yet, I may have the message slightly incorrect but I'm sure you've all seen this at one time or another.
I'm not sure if this is a hardware or software issue. I'm leaning towards either hardware or the BIOS since Windows hasn't yet loaded. I was thinking of pulling cards to isolate it. Before jumping into the project though I thought I might get some tips from you nice people first.
Thanks in advance for any help. Dave

3 replies

by syscokid

Is that all it says? I usually see this accompanied by another message such as "Keyboard error" or "CMOS checksum error" which gives more of a clue to the cause.

Does she also see the computer clock losing time? If the battery is going, the BIOSmight be losing the hard drive settings, requiring her to go into setup on booting, though I admit I've never seen a bad m=battery manifest itself this way before.

Sorry I can't be more definitive without more information.

by azdavid99

I asked my coworker to be more specific on the error msg. She said there is a msg concerning the battery. She also noticed that her clock is losing time. Good call. Sounds exactly like the CMOS battery.
Thanks, Dave

This discussion is closed to new replies.