Discussion Locked

Print System frozen

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Yesterday a got called out on a W2k server that wasn't printing. It has one HP 5500 attached to LPT1. It has two HP Designjet Plotters attached from a Linksys print server via IP. All three mahines are shared. No one on the network was able to print to any printer. I went to the server and tried to print a test page to the locally attached HP 5500 with no luck. Finally I rebooted the server and everything came back fine. The only event I am aware of was the customer upgraded a W98 machine to XP with an XP upgrade. Any clues what could have jammed the print system to the point that I could not print locally from the server? I did notice that the locally attached HP 5500 was not directed to LPT1 when I first arrived. It was redirected to an old IP port that is no longer being used. I assumed that when the customer started having trouble they got on the server and tried fixing it themselves. I am very curious from some of you if you have seen the W2K print system get jammed to the point of requiring a reboot?

3 replies

by jschein

if someone prints to a printer, uses the wrong drivers, the printer will go into limbo... basically, if they are remote printing to a printer via a pc or server, then the machine that is sharing the system would need to have the Spooler service stopped and restarted. This will usually release the printer. If that does not work, a reboot is required.

It's always best to share printers through i.p. addressing with their own network cards, or hp network share devices. Mainly due to the fact of some super einstein who knows everything about computers trys to print something with the wrong driver corrupts the print spooler and the troubleshooting begins.

Good luck.

This discussion is closed to new replies.