Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am new to the IT field so I could use some help. I am on a Windows 2000 network with a inkjet printer attached to machine. When I try to print, it will only print about half the page and then will print a line of garbled text on each additional page until I turn the printer off. It will also keep pulling pages through even though it is set for only one page. I have tried uninstalling and reinstalling the printer as well as the driver. I also tried printing directly to the printer instead of spooling. I ran a virus scan too, but it came back negative. I downloaded SP4 but I don't know if that would help or not. Please help me out.
3 replies
by budthegrey
Lots of things to check...
Bad Cable?
Are you using parallel or USB? have you tried the other interface?
If parallel, have you tinkered with the CMOS LPT port settings (norm/bidir/EPP/ECP/etc)?
Check the manufacturer's web site for updated drivers?
by superman79
Check to see if you have the right printer driver. try to reinstall it and see if it does the same thing.
by ragman
Assuming the printer and cable work on another PC, download the driver again. NT had a problem I thought was fixed in 2K, but it's worth a try. Delete the driver - reboot - then reload the driver again.
What kind of printer is this? Something common or something oddball?
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
1 helpful
16 replies
0 helpful
12 replies
0 helpful
3 replies
0 helpful
2 replies
Question
Is WSL still relevant in 2026?
0 helpful
1 reply