Discussion Locked

Printing thru Linksys BEFSR41

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Linksys BEFSR41 router set up for cable and multiple computers. I want to print to an HP 4300dtns printer with a built-in jet-direct card. The computers can see and share with one another, but the printer is not seen by the computers. The router management software shows the printer as beeing connected. I can print when connected to the LPT1 on one system by sharing but I don't want to tie up one system that way. All my network wires are straight thru. What am I doing wrong?

5 replies

by thechas

1. Are you using the firewall option on the Linksys?
If so, since you cannot install Zone Alarm on the printer, it may be being blocked.

2. Does the printer have a static or dynamic IP?
With a static IP, you can set the firewalls on each PC to allow access to the printer.

3. Have you contacted Linksys tech support?
I have found Linksys tech support to be very knowledgeable and helpful.

Chas

by ctmoore1998

Config JETDIRECT with a static IP address in your local network. Next go to HP website www.hp.com and go to driver downloads. Search for network wizard as the print driver. Down load the wizard for the appropriate OS(s) Get latest print driver also and expand in a local directory, use wizard to connect to the printer (wizard will check internet for latest driver if it recognizes printer) You will need the wizard because 95/98 won't natively print to an IP address.
Check your printer doc's to configure the jet-direct card, newer ones you may have to change ip on a workstation to the default IP of the JD so that you can access it via the web interface, but I believe that on the 4100 you can change the IP via the control panel on ptr. Print the config to verify ptr IP address.

by tidewatermail

The wizard came with the printer, but it must have been faulty. I downloaded a new wizard that work on one computer and showed me an IP problem on the other. The computers could talk to one another, but something was missing so I reinstalled the NIC software. I am up and running. THANK YOU

This discussion is closed to new replies.