5 replies
by lumberjack
fdisk should remove all partitioning details.
if problems within 98, then create a boot disk that has the fdisk.com executable, boot from that - run fdisk - dont forget to change to the problem disk within fdisk then remove all partition details.
reboot Pc, assign drive letter and format disk
good luck!
by jeremy
Poster rated this answer.
by phil.hall
Get a DOS boot floppy with DEBUG.EXE on it and follow the instructions at this site: http://www.computerhope.com/rdebug.htm#3
(Repeated below for simplicity, but there are text formattings that are lost.)
This routine is useful in clearing DDO. If this routine completes successfully it will erase everything in Sector 2.
In the following debug routine only type what is in bold from line 3 to 9 you will get a response if it corresponds with the following type the text after the response without putting in a space between the response and what you type in.
A:\>debug
-FCS:200 400 0
-ACS:100
-xxxx:0100 mov ax,302
-xxxx:0103 mov bx,200
-xxxx:0106 mov cx,2
-xxxx:0109 mov dx, 80
-xxxx:010a int 13
-xxxx:010c int 20
-xxxx:0110 (without typing anything)
-g
Program terminated normally.
-q
by jeremy
Poster rated this answer.
by jeremy
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending