Discussion Locked

Remote Desktop connection

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am having difficulty making a remote connection to my desktop PC running windows XPpro. I have a laptop running XPhome, which i network via 11 Mbps wireless network to the desktop. I want to control my desktop from my laptop accross the internet. Remote desktop was very succesful when the laptop was connected on the wireless network.

I assumed that the remote connection was over the internet since the laptop shares the broadband connection of the desktop. However, when i took the laptop to another location and tried to connect to the broadband assigned IP address (over the internet)of the desktop, the connection could not be made.

When travelling with the laptop I use a shared internet connection. ie I connect to the LAN (10 MBps) which has a broadband connection.

11 replies

by timwalsh

If you are using a firewall at home, the most likely cause of your failure to connect is the firewall. Depending on your firewall model, you must either configure the firewll to allow inbound connections on port 3389, or map port 3389 to your home desktop.

Another possibility is that if you are trying to connect from inside another network, it may not be configured to allow outbound connections on port 3389. You will need to check with the network administrator to see if that is the case.
Hope this helps.

by yoram

You say you were successful on the wireless network. Most Access point will use NAT (Network Address Translation) and firewall between the Internet address and the internal network. I know some of these Wireless Access Point won't even allow you to open specific ports but will only work in a firewall yes/no mode.

If your Access Point allows you to open specific ports, TCP 3389 is the one to open. Otherwise you may be out of luck. I guess we need some more details about your topology to give a full answer.

Good luck!

by dustyd

In addition to the above, you may not be able to use DHCP on your router at home. Assign static IPs to your computers, and route port 3389 to the IP of your desktop.

by tech

Note: sharing the broadband connection over the router does not indicate that you're connecting to the desktop via the internet, instead you are using the LAN connection, which are more permissive on the ports. To check this, when you run the RDC(Remote Desktop Connection), try to check the IP address of your laptop using the "netstat -a" from the command prompt (accessible by typing "cmd" in run). If it shows 192.168.*.* then you're identified by the machine through the local network.

This discussion is closed to new replies.